Medical Professionals and Physical Therapists trust the benefits of the WaterRower and Rowing as an excellent cardio exercise. Burning up to 1000 calories per hour and working out up to 84% of your muscle mass during one exercise, rowing offers a tremendously beneficial exercise without the perceived fatigue and exhaustion often apparent when using other cardio training gym equipment.
John Duke, creator of the WaterRower, was inspired to try his hand at invention while working at a subsidiary for U.S. Steel. He wanted to make an indoor machine that felt as much like real rowing as possible, with a focus on aesthetics. It took him two years to get the design right, moving past failed ideas such as a flipper in the tank instead of a clutch. What began as a series of doodles at his desk turned into a sculptural piece of exercise equipment that upends expectations in two ways: by bringing water indoors, and by looking elegant and artful when stored.
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.

Ever since the earliest recorded references to rowing, the sporting element has been present. An Egyptian funerary inscription of 1430 BC records that the warrior Amenhotep (Amenophis) II was also renowned for his feats of oarsmanship. In the Aeneid, Virgil mentions rowing forming part of the funeral games arranged by Aeneas in honour of his father.[10] In the 13th century, Venetian festivals called regata included boat races among others.[11]
John Duke, creator of the WaterRower, was inspired to try his hand at invention while working at a subsidiary for U.S. Steel. He wanted to make an indoor machine that felt as much like real rowing as possible, with a focus on aesthetics. It took him two years to get the design right, moving past failed ideas such as a flipper in the tank instead of a clutch. What began as a series of doodles at his desk turned into a sculptural piece of exercise equipment that upends expectations in two ways: by bringing water indoors, and by looking elegant and artful when stored.
The WaterRower US office got in on the Pull for a Cure fundraising action and all pulled together to raise money for breast cancer! - - - - As many of you may already know, throughout the month of October, WaterRower has been raising money through our Pull for a Cure fundraiser. For each 500m workout rowed and posted online, we'll be donating $1 towards breast cancer research! Don't forget to get your workouts in before Monday, October 31st! #PullForaCure #WaterRower
Most of the Waterrower range is made of wood harvested from the sustainably managed Appalachian forests of the eastern United States. The machines are extremely well built and are beautiful to look at coming in Ash, Oak or Cherry wood. If you are concerned about having an exercise machine in a living area, then one of the wooden models will fit right in to your living room. They are also extremely quiet in operation due to the wooden construction and the use of a strap rather that a chain. The only thing you can really hear is the swishing sound of the water in the tank as you pull giving you the feeling that you are really on the river!
In sweep or sweep-oar rowing, each rower has one oar, held with both hands. This is generally done in pairs, fours, and eights. In some regions of the world, each rower in a sweep boat is referred to either as port or starboard, depending on which side of the boat the rower's oar extends to. In other regions, the port side is referred to as stroke side, and the starboard side as bow side; this applies even if the stroke oarsman is rowing on bow side and/or the bow oarsman on stroke side.
Essentially, the water rower uses water as it's resistance and the air rower (click here to read our air rowing machine reviews) uses air resistance. Additionally, the resistance of the water gives a very similar feeling to actually rowing in the water. The rowing machines listed above all have fantastic rowing mechanisms that mimic the exact feeling of a rowing a boat.
The proper ratio of effort is about 75 percent lower body and 25 percent upper body. Ensure you’re hitting that by driving through your legs and keeping your hands relaxed. Posture plays a big part, too. Concept 2 recommends imagining your upright profile at noon and tilting from the 11 o’clock position (drive) to the 1 o’clock position (recovery).
The WaterRower Xeno Müller Signature Edition rowing machine is handcrafted in solid ash and finished with honey oak stain for color. The WaterRower Xeno Müller Signature Edition has been specifically designed in collaboration with US Olympian and single scull record holder Xeno Müller. This special edition rower features a wider 17" handle and lower footrests for an increased range. Another special feature is Xeno\'s signature included on the rails of either side of the rower thus inspiring you to row like an Olympian!
In sweep or sweep-oar rowing, each rower has one oar, held with both hands. This is generally done in pairs, fours, and eights. In some regions of the world, each rower in a sweep boat is referred to either as port or starboard, depending on which side of the boat the rower's oar extends to. In other regions, the port side is referred to as stroke side, and the starboard side as bow side; this applies even if the stroke oarsman is rowing on bow side and/or the bow oarsman on stroke side.
The tank of the WaterRower Oxbridge Rower is made from polycarbonate, one of the strongest plastics available. It is virtually indestructible. The tank is sealed and can be filled with municipal water via a small opening closed by a stopper. This water typically contains enough chlorine to remain clear for some time. After exposure to light, the chlorine will degrade; the chlorine tablets should be added periodically.
Blades, otherwise known as oars to amateurs or non rowers, are used to propel the boat. They are long (sculling: 250–300 cm; sweep oar: 340–360 cm) poles with one flat end about 50 cm long and 25 cm wide, called the blade. Classic blades were made out of wood, but modern blades are made from more expensive and durable synthetic material, the most common being carbon fiber.
This twenty minutes duration technique is designed to max your muscles out every interval, and at the same time the recovery periods assist in increasing the efficiency with the fat burning routine. Once you have prepared your rowing machine, set its resistance to four. Perform sets of ten, fifteen and twenty power strokes by pulling to handle towards the torso of your body, like doing a rowing motion. Do this motion as fast as your body permits you to. Separate your power strokes at sixty seconds, putting in only fifty percent the effort you did before this. Repeat this cycle until you have fully rowed for a total of twenty minutes.
The WaterRower Club is hand crafted in solid Ash and stained for color. The WaterRower Club has been designed for High Traffic Areas such as Commercial Gyms, Studios, Rehabilitation Clinics, etc. Its Black Rails have been styled to prevent scuffing, other wooden components are finished in an attractive rosewood which is more resistant to soiling than the Natural model.

The recovery phase follows the drive. The recovery starts with the extraction and involves coordinating the body movements with the goal to move the oar back to the catch position. In extraction, the rower pushes down on the oar handle to quickly lift the blade from the water and rapidly rotates the oar so that the blade is parallel to the water. This process is sometimes referred to as feathering the blade. Simultaneously, the rower pushes the oar handle away from the chest. The blade emerges from the water square and feathers immediately once clear of the water. After feathering and extending the arms, the rower pivots the body forward. Once the hands are past the knees, the rower compresses the legs which moves the seat towards the stern of the boat. The leg compression occurs relatively slowly compared to the rest of the stroke, which affords the rower a moment to recover, and allows the boat to glide through the water. The gliding of the boat through the water during recovery is often called run.
Assembled dimensions: 83L x 24W x 20H inches. Complete aerobic and resistance exercise. Folds for easy storage. Easy-to-use monito...r keeps you on track. Eco-friendly ash wood frame, some assembly required. Assembled weight: 143 lbs.. Manufacturer's warranty included (see product guarantee). Premium hardwood frame of sustainable ash with Danish oil finishBlack rails prevent scuffing; redwood finish is handsome and soil-resistantWater tank ensures smooth-gliding motion and is easy to maintainEasy-to-use training monitor tracks stroke rate, intensity, distance, and timeEasy to assemble with only a 5mm Allen Key wrench (included)Quality seat wheels mounted on durable rails for dependable, smooth movementHandlebars, seat, and footrest are comfortable and durableWorks 84 percent of muscle mass for maximum resultsCombines aerobic workout and resistance for total body reshapingManufacturer's warranty included: see complete details in the Product Guarantee areaDisclaimer:WaterRower will not provide support or documentation for any product transported outside of the original country of purchase. read more
The WaterRower Club Rower has been designed for high traffic areas such as commercial gyms, studios, rehabilitation clinics, etc. Its black rails have been styled to prevent scuffing; other wooden components are finished in an attractive rosewood which are more resistant to soiling than the natural model. Each machine has been hand finished with Danish oil and urethane for protection. Wood has been chosen due to its marvelous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the waterrower's quietness and smoothness of use. Ash, like all woods used in WaterRower construction, is a premium hardwood with incredible longevity and dimensional stability. For reasons of ecology, all WaterRower woods are harvested from replenishable forests. WaterRower Club Rower Black Rails have been styled to prevent scuffing, other wooden components are finished in an attractive rosewood which are more resistant to soiling than the Natural model.
Blades, otherwise known as oars to amateurs or non rowers, are used to propel the boat. They are long (sculling: 250–300 cm; sweep oar: 340–360 cm) poles with one flat end about 50 cm long and 25 cm wide, called the blade. Classic blades were made out of wood, but modern blades are made from more expensive and durable synthetic material, the most common being carbon fiber.
The First Degree Fitness Challenge AR (Adjustable Resistance) is designed and engineered by professional rowers and craftsman using only the highest degree of quality components – ensuring complete satisfaction in function, performance, and reliability.  With its patented Fluid Technology, First Degree Fitness has incorporated the truest emulation of sensation, sight, and sound of real on-water rowing captured in the private setting of your own home.
At its founding, it had nine clubs; today, there are 12: Fairmount Rowing Association, Crescent Boat Club, Bachelors Barge Club, University Barge Club, Malta Boat Club, Vesper Boat Club, College Boat Club, Penn Athletic Club Rowing Association (Penn AC), Philadelphia Girls' Rowing Club (PGRC), Gillin Boat Club and St. Joseph's University and St. Joseph's Prep. At least 23 other clubs have belonged to the Navy at various times.[23] Many of the clubs have a rich history, and have produced a large number of Olympians and world-class competitors.[26]
The meter didn't work properly. It wasn't keeping the distance - we would row for 30 mins and wouldn't even be at 1km!!! And the strokes per minute was reading double strokes (which the company said was normal - huh?). Their customer service team was good and tried to make it work but we ended up returning it and spent the extra money to get a WaterRower and it is amazing!!!
The Apollo Pro 2 water rower is a commercial grade, natural wood rowing machine, perfect for group training or high-end home gyms. This rower’s water resistant design, meditative motion and integrity of construction sets it apart from its competitors. Handcrafted from the finest quality American Ash wrapped around a stabilising steel frame, this steadfast indoor rower offers a standout performance even in the harshest of fitness applications.
If you are anything like me, you read the negative reviews to see what some of the complaints could potentially be...I have found none that match with my machine or experience so far. The boxes it came in were a little bunged-up but everything on the inside was perfect. Only took about 15-20 minutes to build (first time building a row machine) and another 5-10 to fill with water. We used it for a little while before we added the danish oil.
The most commonly damaged piece of rowing equipment is the skeg, which is a metal or plastic fin that comes out of the bottom of the boat to help maintain stability, and to assist in steering. Since the skeg sticks out below the hull of the boat it is the most vulnerable to damage, however it is relatively easy to replace skegs by gluing a new one on. Hull damage is also a significant concern both for maintaining equipment, and for rower safety. Hull damage can be caused by submerged logs, poor strapping to trailers, and collisions with other boats, docks, rocks, etc.
When a product is listed as Pre-Order, such product is not yet in stock but is available for advanced purchase on our site, prior to the manufacturer's public release date. Pre-Order items are shipped once in stock and the public release date arrives. You will be notified of a product's updated status by email. The expected shipment time is listed on the Product Detail page.

In addition to this, certain crew members have other titles and roles. In an 8+ the stern pair are responsible for setting the stroke rate and rhythm for the rest of the boat to follow. The middle four (sometimes called the "engine room" or "power house") are usually the less technical, but more powerful rowers in the crew, whilst the bow pair are the more technical and generally regarded as the pair to set up the balance of the boat. They also have most influence on the line the boat steers.

×