The WaterRower Natural Rowing Machine with S4 Monitor is hand crafted in solid Ash and stained Honey Oak for consistency of color.... Each rowing machine has been hand finished with Danish Oil giving a deep luster and warmth to the wood. Wood has been chosen due to its marvelous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the WaterRower's smooth and quiet performance.;Flywheel sits in enclosed water tank to provide smooth, quiet, self-regulated resistanceSeries 4 performance monitor tracks workout intensity, stroke rate, heart rate, and moreHandcrafted rowing machine with inchwater flywheel inch that replicates actual rowing feelStores upright; measures 84 x 21 x 22 inches (W x H x D) and weighs 117 poundsStores upright; measures 84 x 21 x 22 inches (W x H x D) and weighs 117 pounds read more
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
In sweep or sweep-oar rowing, each rower has one oar, held with both hands. This is generally done in pairs, fours, and eights. In some regions of the world, each rower in a sweep boat is referred to either as port or starboard, depending on which side of the boat the rower's oar extends to. In other regions, the port side is referred to as stroke side, and the starboard side as bow side; this applies even if the stroke oarsman is rowing on bow side and/or the bow oarsman on stroke side.
×