WaterRower (UK) Ltd was formed in 1991 to market and distribute the WaterRower throughout Europe under license to WaterRower Inc. Initially with offices in Fulham, London, a 1993 agreement provided WaterRower (UK) Ltd with the additional right to manufacture the WaterRower for Europe. Workshops were established in the idyllic stately home of the Earl and Countess of Sandwich, Mapperton Manor 
Unlike traditional rowboats or kayaks, sliding seat rowing shells are quality fitness tools that allow you a low-impact, all-over body workout. Our versatile shells are simple to operate, stable in open water conditions, and effective in providing you with a fun, safe workout, whether you are a novice or an experienced rower. Our unique folding riggers and long Delta keel make our boats portable and easy to launch.

The rowing machine itself is unlike any other on the market with its patented water filled flywheel. It is hard to exactly copy the action of a scull on the water, but the mechanics of the flywheel spinning in water comes in a close second on dry land. The fact that the water is 800 times denser than air means that there is no need for any extra resistance or dampening that you will find in normal air rowers. The faster you pull, the more resistance is generated giving it infinite variability. However, if you want to be able to practice rowing with a faster stroke, you will have to reduce the amount of water in the tank unlike an air rower where you just have to adjust the baffle.
Yes! The mother of indoor rowing competitions is the CRASH-B Sprints, held annually in Boston. The Charles River All-Star Has-Beens started when the U.S. boycotted the Olympics in 1980 — during the same era that Concept 2 launched their Model A; necessity met opportunity. CRASH-B is still held with aplomb and doesn’t require any special qualification of its applicants.
This twenty minutes duration technique is designed to max your muscles out every interval, and at the same time the recovery periods assist in increasing the efficiency with the fat burning routine. Once you have prepared your rowing machine, set its resistance to four. Perform sets of ten, fifteen and twenty power strokes by pulling to handle towards the torso of your body, like doing a rowing motion. Do this motion as fast as your body permits you to. Separate your power strokes at sixty seconds, putting in only fifty percent the effort you did before this. Repeat this cycle until you have fully rowed for a total of twenty minutes.
Decreasing  speed of waves as water becomes shallow has dramatic consequences on the beach. As the waves slow, their profile (Figure on right) is laterally compressed and since each wave must carry the same energy it becomes higher. As the wave approaches shore this process continues until the height exceeds 1/7 th the wave length and the wave becomes unstable. Then the wave breaks.
Tank: The tank of the WaterRower M1 LoRise is made from polycarbonate, one of the strongest plastics available. It is virtually indestructible. The tank is sealed and can be filled with municipal water via a small opening closed by a stopper. This water typically contains enough chlorine to remain clear for some time. After exposure to light, the chlorine will degrade and the chlorine tablets included free with the WaterRower M1 LoRise should be added periodically.
The WaterRower Classic Rower is hand crafted in solid American Black Walnut. Like all woods, Black Walnut may vary in color from a rich brown to purple-black. Each machine has been hand finished with three coats of Danish Oil giving a deep luster an warmth to the wood. The wood has been chosen due to its marvelous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the WaterRower's quietness and smoothness of use. Black Walnut, like all woods used in WaterRower construction, is a premium hardwood with incredible longevity and dimensional stability. For reasons of ecology, all our woods are harvested from replenishable forests.
Outside of resistance type, we found the number-one arbiter of ride feel to be cord quality. Water ergometers tend to employ nylon cords, while air ergometers feature metal chains — a durability factor we anticipated would result in our favoring air. But while all three water rowers aced our expectation of smooth, high-tension strokes, perfecting the chain seems to be more difficult: Some tug with just a slight rumble, others feature bouncy, grinding chains that are incredibly loud, something akin to angry snoring. As for nylon, the best wind and unwind like elastic silk — no slack, no sound, no catching, just perfectly even tension throughout the stroke.
Open water rowing is an ALL-BODY SPORT, toning your arms, legs, chest, back, and abs. Rowing is also recognized as a COMPLETE CARDIOVASCULAR WORKOUT which is highly aerobic and burns calories quickly. What most people don't realize is that rowing IMPROVES JOINT HEALTH through a wide range of motion. In addition, open water rowing RELIEVES STRESS and allows you the opportunity to remove yourself from the world around you, to connect to the calm and quiet of the water, and to meditate through the rhythmic, repetitive motion of your stroke.
The WaterRower US office got in on the Pull for a Cure fundraising action and all pulled together to raise money for breast cancer! - - - - As many of you may already know, throughout the month of October, WaterRower has been raising money through our Pull for a Cure fundraiser. For each 500m workout rowed and posted online, we'll be donating $1 towards breast cancer research! Don't forget to get your workouts in before Monday, October 31st! #PullForaCure #WaterRower
The Verified Sustainable Hardwoods used for the WaterRower are sourced from the Appalachian Mountain region of the eastern United States, where planting rates exceed harvest rates by an average multiple of 2.29. The Appalachian Hardwood Timber resource includes more than 65.4 million acres in the eastern United States and provides the world with a bounty of the finest hardwood species.
The WaterRower Oxbridge Rower in Cherrywood is designed for equally gorgeous look and performance. Every detail complements the overall aesthetic and performance of this unparalleled machine. Built in America, the WaterRower Oxbridge Rower in Cherrywood is a product of modern European design. It's hand-crafted in solid ash and stained honey oak for consistency of color. Each machine has been hand-finished with Danish Oil, which lends a deep warmth and luster. Wood has been chosen for its marvelous engineering properties; primary amongst these is its ability to absorb sound and vibration, which enhances the WaterRower Oxbridge Rower quietness and smoothness of use. Ash, like all woods used in WaterRower construction, is a premium hardwood with incredible longevity and dimensional stability. For reasons of ecology, all woods are harvested from renewable forests. The frame is more than stylish; it holds up to 2,200 lbs!
When waves run into water moving in the opposite direction, they are slowed, just as if they were approaching a beach. Wave length becomes shorter, wave height higher, and they may break. A good (bad) example of this is an ebb current flowing out of Raccoon Strait into waves coming in from the Golden Gate. Good rough water training, if that’s what you want.
If the machine is to be housed on a wooden floor you will need a mat beneath to reduce vibration and also noise. If space is tight, the hydraulic options are usually the smallest. It's also worth checking your floor can take the weight if you're going for one of the bigger, heavier models. For most, this shouldn't be a problem, if you have any doubts get a surveyor to check as it could be a very expensive mistake!

When a product is listed as Pre-Order, such product is not yet in stock but is available for advanced purchase on our site, prior to the manufacturer's public release date. Pre-Order items are shipped once in stock and the public release date arrives. You will be notified of a product's updated status by email. The expected shipment time is listed on the Product Detail page.
In the 1950s- and 1960s, more sports coaches began to use rowing machines for training and assessment of athletes' performance. One such rower developed at this time was the Harrison-Cotton machine, the brainchild of John Harrison of Leichhardt Rowing Club in Sydney and Professor Frank Cotton, produced by Ted Curtain Engineering. This was the very first piece of equipment able to measure athletic power with great accuracy, and it also imitated the actual experience of rowing more closely than any previous rowing machine.

According to Fritz Hagerman, Ph.D., a professor in the Biological Science Department at Ohio University, “Competitive rowers expended almost twice the number of calories on a 2,000-meter course as a runner in a 3,000-meter steeplechase.”1 However, since rowing is low impact, you will not experience the same wear and tear on your body that you would if you were a runner. Plus, you build strength in your upper body and core.
Founded in 1818, Leander Club is the world's oldest public rowing club.[17] The second oldest club which still exists is the Der Hamburger und Germania Ruder Club which was founded 1836 and marked the beginning of rowing as an organized sport in Germany.[18] During the 19th century, as in England, wager matches in North America between professionals became very popular attracting vast crowds. Narragansett Boat Club was founded in 1838 exclusively for rowing. During an 1837 parade in Providence, R.I, a group of boatmen were pulling a longboat on wheels, which carried the oldest living survivor of the 1772 Gaspee Raid. They boasted to the crowd that they were the fastest rowing crew on the Bay. A group of Providence locals took issue with this and challenged them to race, which the Providence group summarily won. The six-man core of that group went on the following year to found NBC in 1838.[19] Detroit Boat Club was founded in 1839 and is the second oldest continuously-operated rowing club in the U.S. In 1843, the first American college rowing club was formed at Yale University.[20] The Harvard–Yale Regatta is the oldest intercollegiate sporting event in the United States,http://rowinghistory.net/Time%20Line/TL%20-1849images.htm[21] having been contested every year since 1852 (excepting interruptions for wars). 

The WaterRower Classic Rower is outfitted with a Series 4 performance monitor that's designed to balance technical sophistication with user-friendliness. The monitor--which includes six information and programming windows, six QuickSelection buttons, and three navigation buttons--displays your workout intensity, stroke rate, heart rate, zone bar, duration, and distance. Plus, the monitor is compatible with an optional heart rate chest strap and receiver, which helps you optimize your workout and achieve your exercise objectives.


In the rowing machine category, there are a lot of models to chose from. They range in price from under $100 to well over $1500.  As you can imagine, you’re getting a different type of row machine at those ends of the spectrum, but within that variety there’s something for everyone.  To help guide you, we’ve listed our favorite row machine models and brands by price below:

A bumps race is a multi-day race beginning with crews lined up along the river at set intervals. They start simultaneously and all pursue the boat ahead while avoiding being bumped by a boat from behind. If a crew overtakes or makes physical contact with the crew ahead, a bump is awarded. As a result, damage to boats and equipment is common during bumps racing. To avoid damage the cox of the crew being bumped may concede the bump before contact is actually made. The next day, the bumping crew will start ahead of any crews that have been bumped. The positions at the end of the last race are used to set the positions on the first day of the races the next year. Oxford and Cambridge Universities hold bumps races for their respective colleges twice a year, and there are also Town Bumps races in both cities, open to non-university crews. Oxford's races are organised by City of Oxford Rowing Club[41] and Cambridge's are organised by the Cambridgeshire Rowing Association.
The rowing machine itself is unlike any other on the market with its patented water filled flywheel. It is hard to exactly copy the action of a scull on the water, but the mechanics of the flywheel spinning in water comes in a close second on dry land. The fact that the water is 800 times denser than air means that there is no need for any extra resistance or dampening that you will find in normal air rowers. The faster you pull, the more resistance is generated giving it infinite variability. However, if you want to be able to practice rowing with a faster stroke, you will have to reduce the amount of water in the tank unlike an air rower where you just have to adjust the baffle.
×