The horizontal movement of the water when a wave passes is approximately equal to the up and down movement of the water. If you are on flat water and are parallel to waves made by a passing boat, your boat will move side-to-side as much as up-and–down as the wave passes under you. The side-to-side movement actually creates most of the difficulty in balancing the boat in such a situation. However, under typical conditions in the bay there can be such varied wave action that you can’t easily distinguish horizontal and vertical motion.
Chris Kinsey works as an editor for a medical publisher and has experience dealing with many topics, ranging from athlete's foot to cancer and brain injury. Kinsey has a great deal of freelance experience writing for sports and parenting magazines as well. Kinsey holds a Bachelor of Arts in communications from California University of Pennsylvania.
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
Single, and double sculls are usually steered by the scullers pulling harder on one side or the other. In other boats, there is a rudder, controlled by the coxswain, if present, or by one of the crew. In the latter case, the rudder cable is attached to the toe of one of his shoes which can pivot about the ball of the foot, moving the cable left or right. The bowman may steer since he has the best vision when looking over his shoulder. On straighter courses, the strokesman may steer, since he can point the stern of the boat at some landmark at the start of the course. On international courses, landmarks for the steersmen, consisting of two aligned poles, may be provided.
Like all woods, Cherrywood may vary in color from a red-brown to deep red. The wood will darken in color with exposure to light. For this reason all WaterRower Cherrywood components are kept in light free rooms to protect from shadowing. A new WaterRower Oxbridge Rower will therefore appear quite light in color. The wood will however darken over time reaching a rich reddish hue.
Do you need a machine that folds up? If you've decided to avoid a water rower for space reasons, you may prefer a model that folds up for storage. Even better, some rowing machines have wheels fitted to them, so that once it's folded up, you can steer it to a storage space out of the way. You can find a foldable design in many magnetic and some air rowers.
Water rowers feature a tank that is actually filled with water as a means for resistance. As you increase the pace of rowing, the resistance naturally increases as well. This means that you can set your own pace and resistance in a single motion. The same is true for air rowers. Air rowers use a fan or flywheel to create resistance, and you have control over the intensity of the workout due to the fact that the air resistance depends on your pace. Most water and air rowers come equipped with -- or at least have as an option -- monitors that track various functions such as distance, strokes, strokes per minute and calories burned.
Major domestic competitions take place in dominant rowing nations and include The Boat Race and Henley Royal Regatta in the United Kingdom, the Australian Rowing Championships in Australia, the Harvard–Yale Regatta and Head of the Charles Regatta in the United States, and Royal Canadian Henley Regatta in Canada. Many other competitions often exist for racing between clubs, schools, and universities in each nation.
The most commonly damaged piece of rowing equipment is the skeg, which is a metal or plastic fin that comes out of the bottom of the boat to help maintain stability, and to assist in steering. Since the skeg sticks out below the hull of the boat it is the most vulnerable to damage, however it is relatively easy to replace skegs by gluing a new one on. Hull damage is also a significant concern both for maintaining equipment, and for rower safety. Hull damage can be caused by submerged logs, poor strapping to trailers, and collisions with other boats, docks, rocks, etc.

The WaterRower Club Rower has been designed for high traffic areas such as commercial gyms, studios, rehabilitation clinics, etc. Its black rails have been styled to prevent scuffing; other wooden components are finished in an attractive rosewood which are more resistant to soiling than the natural model. Each machine has been hand finished with Danish oil and urethane for protection. Wood has been chosen due to its marvelous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the waterrower's quietness and smoothness of use. Ash, like all woods used in WaterRower construction, is a premium hardwood with incredible longevity and dimensional stability. For reasons of ecology, all WaterRower woods are harvested from replenishable forests. WaterRower Club Rower Black Rails have been styled to prevent scuffing, other wooden components are finished in an attractive rosewood which are more resistant to soiling than the Natural model.


I kayak (ocean and flat water, not river), so I was drawn to the WaterRower over a flywheel type rower (which I have used in gyms) because I wanted to hear the sound of the water, which I miss hearing against the hull of the boat during the winter when I can't get out on the lake. I also like the way the paddles engage in the water; it's a very smooth pull and release, and moving the mass of the water instead of a dialed down tension feels more natural. As someone else also commented, the seat (at least on the wood version) is incredibly smooth and solid; no wobbling at all. I generally listen to music on my Nordic Track ski machine, but with the WaterRower I am content to listen to the sound of the water; working out on this is somehow both energizing and calmingly meditative at the same time. In the event that you want to use it while watching tv (this is one use to which I wanted to put it), it is quiet enough to hear the tv without having to turn it up.
Blades, otherwise known as oars to amateurs or non rowers, are used to propel the boat. They are long (sculling: 250–300 cm; sweep oar: 340–360 cm) poles with one flat end about 50 cm long and 25 cm wide, called the blade. Classic blades were made out of wood, but modern blades are made from more expensive and durable synthetic material, the most common being carbon fiber.
Most people who are new to the sport of rowing have difficulty achieving low strokes rates while trying to obtain their desired intensity – there are many comments such as “it does not feel hard enough?” or “how can I make it harder?” Rowing is about ratio and rhythm and you need to focus on a long stroke length and a powerful drive phase (push with the legs and pull with the arms). Give yourself time to learn this, it can take a few weeks before you start to feel the intensity at low stroke rates.
Award Winning Design - The WaterRower has been designed to set it apart from other fitness equipment, featuring an attention to detail unseen in other exercise equipment. Refined Design - The WaterRower has been designed to set it apart from other fitness equipment, featuring an attention to design refinement unseen in other exercise equipment. Hand Crafting - WaterRower’s wooden models are handcrafted from a selection of the world’s finest hard woods (Ash, Cherry, Walnut, Beech and Oak).. Each model is hand finished and coated with Danish oil giving it a deep penetrating Luster. Sustainable & Eco-Friendly - All WaterRower's wooden models are crafted from the finest Appalachian hardwoods sourced only from replenishable forests.
Originally made from wood, shells are now almost always made from a composite material (usually a double skin of carbon-fibre reinforced plastic with a sandwich of honeycomb material) for strength and weight advantages. FISA rules specify minimum weights for each class of boat so that no individual team will gain a great advantage from the use of expensive materials or technology.
Storage is also a plus point for the Waterrower series as they are all designed to stand upright with the tank acting as ballast for stability. In this position they only take up around two square feet. Again, great if you are planning on training in the living room. However, if you have small children, I would advise fixing the top to the wall with a hook and strap.
The frame is beyond durable and is designed for absorbing sound and vibration. There’s no creaking or other sounds that you might expect from wood components. It has a low center of gravity that keeps the rower in place while exerting full rowing power. The polycarbonate water tank is equally durable and practically indestructible. The Classic Rower doesn’t have any moving parts that can wear out, or belts and pulleys that need to be maintained.
WaterRower Rowing Machines offer a pleasant rowing exercise while holding true to the dynamics of on-water rowing; burn up to 1000 calories an hour and work up to 84 percent of your muscle mass! Rowing provides an effective, high-intensity, cardio workout, while maintaining a low-impact to the joints. Workout at your own pace as the WaterFlyWheel's self-regulating resistance dynamically adjusts to each of your strokes. Unlike common ergometers, to change resistance on a WaterRower rowing machine you simply row harder!
Handcrafted rowing machine with inchwater flywheel inch that replicates actual rowing feelFlywheel sits in enclosed water tank to ...provide smooth, quiet, self-regulated resistanceSeries 4 performance monitor tracks workout intensity, stroke rate, heart rate, and moreHandcrafted rowing machine with "water flywheel" that replicates actual rowing feel read more
As previously discussed, the rowing machine’s big advantage is that it provides more than just a cardio workout. It can definitely help you build muscle and lose weight. Compared to a treadmill, the rowing machine works most of your body. It will really hit your shoulders, core, quads, hamstrings, glutes, arms and back effectively while being low impact thus reducing the stress on your joints. Bigger muscles need more energy and will burn fat to get it, which of course leads to healthy weight loss.
Reviews.com has an advertising relationship with some of the offers included on this page. However, the rankings and listings of our reviews, tools and all other content are based on objective analysis. For more information, please check out our full Advertiser Disclosure. Reviews.com strives to keep its information accurate and up to date. The information in our reviews could be different from what you find when visiting a financial institution, service provider or a specific product’s website. All products are presented without warranty.
The WaterRower Natural Rowing Machine with S4 Monitor is hand crafted in solid Ash and stained Honey Oak for consistency of color.... Each rowing machine has been hand finished with Danish Oil giving a deep luster and warmth to the wood. Wood has been chosen due to its marvelous engineering properties, primary amongst these is its ability to absorb sound and vibration enhancing the WaterRower's smooth and quiet performance.;Flywheel sits in enclosed water tank to provide smooth, quiet, self-regulated resistanceSeries 4 performance monitor tracks workout intensity, stroke rate, heart rate, and moreHandcrafted rowing machine with inchwater flywheel inch that replicates actual rowing feelStores upright; measures 84 x 21 x 22 inches (W x H x D) and weighs 117 poundsStores upright; measures 84 x 21 x 22 inches (W x H x D) and weighs 117 pounds read more
×