Amateur competition in England began towards the end of the 18th century. Documentary evidence from this period is sparse, but it is known that the Monarch Boat Club of Eton College and the Isis Club of Westminster School were both in existence in the 1790s. The Star Club and Arrow Club in London for gentlemen amateurs were also in existence before 1800. At the University of Oxford bumping races were first organised in 1815 when Brasenose College and Jesus College boat clubs had the first annual race[14] while at Cambridge the first recorded races were in 1827.[15] Brasenose beat Jesus to win Oxford University's first Head of the River; the two clubs claim to be the oldest established boat clubs in the world. The Boat Race between Oxford University and Cambridge University first took place in 1829, and was the second intercollegiate sporting event (following the first Varsity Cricket Match by 2 years). The interest in the first Boat Race and subsequent matches led the town of Henley-on-Thames to begin hosting an annual regatta in 1839.[16]

Fetch is the distance over which the wind interacts with the water surface to creates waves. The longer the fetch the bigger (higher) the waves are. If the shore (green in the diagram) is a hill, there will be a wind shadow which gives protection from the wind, but even if the shore is flat as a pancake and gives no protection, the waves become progressively smaller as you for upwind to the shore. Thus, rowing upwind toward shore is always an escape from waves.

This rower has been designed to ensure stroke consistency and utilises a triple blade impeller system. Perfect for smaller houses or apartments, this model includes the easy tilt feature for fast fold-up and storing. Assembly is a one man job that will take twenty to thirty minutes to complete. A step by step illustrated instruction manual has been included, in addition to all of the tools needed for this process.
Assembly was challenging. One of the rails could not be attached because the embedded screw in the cross-beam was too crooked to fit into the hole on the rail. I had to place a nut on it to protect the screws and tap until it was true enough cap nut to be attached. The foot board is slightly wider than the top board. I will sand this to match when I reapply the finish. This will need to be done because the wood has a dry, ashy appearance. The wood is beautiful and mostly uniform. This rowing machine is a nice product, but the build quality of the unit I received was disappointing. I felt lucky that the gashes in the carton did not damage the product as the packaging was optimistic. The leading competitor I use at the gym seems to provide slightly more resistance. It is beautiful and useful, but with room for improvement.
Rowing is a low impact sport with movement only in defined ranges, so twist and sprain injuries are rare. However, the repetitive rowing action can put strain on knee joints, the spine and the tendons of the forearm, and inflammation of these are the most common rowing injuries. [9]If one rows with poor technique, especially rowing with a curved rather than straight back, other injuries may surface, including back pains. Blisters occur for almost all rowers, especially in the beginning of one's rowing career, as every stroke puts pressure on the hands, though rowing frequently tends to harden hands and generate protective calluses. Holding the oars too tightly or making adjustments to technique may cause recurring or new blisters, as it is common to feather the blade (previously described). Another common injury is getting "track bites", thin cuts on the back of one's calf or thigh caused by contact with the seat tracks at either end of the stroke.
In sweep or sweep-oar rowing, each rower has one oar, held with both hands. This is generally done in pairs, fours, and eights. In some regions of the world, each rower in a sweep boat is referred to either as port or starboard, depending on which side of the boat the rower's oar extends to. In other regions, the port side is referred to as stroke side, and the starboard side as bow side; this applies even if the stroke oarsman is rowing on bow side and/or the bow oarsman on stroke side.