Most races that are held in the spring and summer feature side by side racing, or sprint racing, sometimes called a regatta; all the boats start at the same time from a stationary position and the winner is the boat that crosses the finish line first. The number of boats in a race typically varies between two (which is sometimes referred to as a dual race) to eight, but any number of boats can start together if the course is wide enough.
Decreasing  speed of waves as water becomes shallow has dramatic consequences on the beach. As the waves slow, their profile (Figure on right) is laterally compressed and since each wave must carry the same energy it becomes higher. As the wave approaches shore this process continues until the height exceeds 1/7 th the wave length and the wave becomes unstable. Then the wave breaks.
You are eligible for a full refund if no ShippingPass-eligible orders have been placed. You cannot receive a refund if you have placed a ShippingPass-eligible order. In this case, the Customer Care team will remove your account from auto-renewal to ensure you are not charged for an additional year and you can continue to use the subscription until the end of your subscription term.
The WaterRower Club is hand crafted in solid Ash and stained for color. The WaterRower Club has been designed for High Traffic Areas such as Commercial Gyms, Studios, Rehabilitation Clinics, etc. Its Black Rails have been styled to prevent scuffing, other wooden components are finished in an attractive rosewood which is more resistant to soiling than the Natural model.
In deep water the speed (or velocity) of a water wave depends only on its wave length. Specifically, the speed is proportional to the square root of the wavelength. Thus, the longer the wave length, the faster the wave, or vice versa. The speed of a single wave is called the phase speed. Amazingly, the speed of a packet of waves (the group speed) is often not the same.
A bumps race is a multi-day race beginning with crews lined up along the river at set intervals. They start simultaneously and all pursue the boat ahead while avoiding being bumped by a boat from behind. If a crew overtakes or makes physical contact with the crew ahead, a bump is awarded. As a result, damage to boats and equipment is common during bumps racing. To avoid damage the cox of the crew being bumped may concede the bump before contact is actually made. The next day, the bumping crew will start ahead of any crews that have been bumped. The positions at the end of the last race are used to set the positions on the first day of the races the next year. Oxford and Cambridge Universities hold bumps races for their respective colleges twice a year, and there are also Town Bumps races in both cities, open to non-university crews. Oxford's races are organised by City of Oxford Rowing Club[41] and Cambridge's are organised by the Cambridgeshire Rowing Association.
Row your way to fitness with this water rowing machine from WaterRower. The A1 S4 Natural is a low-maintenance exercise machine th...at's constructed from high-quality ash wood with aluminum mono rail. Engineered with the patented WaterFlywheel resistance method, it provides life-like water rowing experience while the low noise level and minimal intrusion along with the unique self-regulating resistance with infinite variable allows suits any user without the need for adjustments. With its no impact and non-load bearing, this gym equipment is also perfect for users with joint problems. Exercise all major muscle groups like the arms, legs, back, shoulders, core, etc. and see how great you're doing with the help of the S4 monitor that comes with the package. It monitors time per 2 or 500 kilometers, watts, calories burned per hour, distance, and the total time of workouts. This exercise machine also boasts minimal maintenance with no lubrication needed. You simply need to add purification tablet every 3-6 months (tablets come with the package). Storage is easy and hassle-free as well. Simply tip the machine vertically and you can easily lean it against a wall or hide it inside a closet. Moreover, enjoy 1 year manufacturer warranty (can be upgraded to 3 years parts and 5 years frame warranty for free with registration) read more
SquareTrade Protection Plans are only valid for new or Amazon certified refurbished products purchased at Amazon in the last 30 days. By purchasing this Protection Plan you agree to the Protection Plan Terms & Conditions (http://www.squaretrade.com/terms-standard). Your Protection Plan Terms & Conditions will be delivered via email within 24 hours of purchase
After reading so many fantastic reviews I purchased the Classic model. Before I write what I think are the negative aspects I'll say that it gives a great workout! That is pretty obvious and I don't think that part is arguable. The disappointment began while unpacking. The wood parts were wrapped fairly well and did not have damage but there were several scratches that I had to sand out and re-oil. It appears that they were there before shipping. Putting it together would have been fast and easy- except 2 of the bolts were bent at about 15 degrees and would not fit. I had to wrap with tape and bend with vice grips. After getting it all together the rower worked well for about a week. I started to notice an annoying kind of popping sound from the left rail as the wheels rolled over on each stroke and recovery. It seems the plastic that the wheels ride on is not flat or adhered well to the rail. It isn't very loud but I can hear it well and it gets my attention, spoiling the nice sound of the water. Really disturbing. Support at WaterRower would like a video of the issue. Seems like an obvious issue and could swap out with a rail that is good instead of me trying to make a video of this small sound while moving the seat back and forth. For a $1500 machine the quality control- or lack of it is disturbing. Having to jump through a bunch of hoops because they are too cheap to just send a part is even more so. Perhaps I am being difficult but it is upsetting to have something touted as so great but put together like a $200 piece of junk. Another complaint would be the lack of any back lighting on the monitor. Really cannot see it if the lights are low. Being able to remove the monitor to attach to a PC wouldn't hurt either. While it gives a good workout the rower really suffers from poor manufacturing.
Rifles Delivery Confirmation-Adult Signature Required. Customer must provide a physical address for delivery of this item. Cannot ship to a PO Box or APO/FPO addresses. Black powder rifles are not shipped to customers in IL, MI, NJ, NY and Washington, DC because of restrictions. This item will be removed from your order if your shipping address is to a restricted location.
There is much to love about the WaterRower--and I do love it--but I would echo others' comments that although the seat rolls solidly and smoothly on the wood rails, the seat itself is very hard (I use a gel seat pad I bought for my hard fiberglass kayak seat), and the footpads are in need up rethinking and upgrading--the cheap plastic doesn't let you row in socks or barefoot and is not really worthy of a machine that is otherwise a stunning piece of engineering and a beautiful one as well. As one other person noted about his machine, my machine made a clicking noise on the return stroke, so I had to adjust the wheel underneath the top rail that connects to the footpad and pull it away gently from where it was rubbing against another component. Also, be warned: the instruction booklet is in the DVD case. I did not see the little sticker on the case telling me that, thinking I'd wait to watch the DVD until after I'd assembled it. But WaterRower has a copy of the assembly instructions on their website, along with a video (I found the written ones better and easier to follow), so I was able to assemble it with no difficulty.
Rowing machines were first used in Archaic Greece. Chabrias, an Athenian military general in 4th Century B.C., invented wooden rowing simulators for his inexperienced oarsmen. This enabled them to learn technique and timing before stepping foot on actual water crafts. And it must have worked — Chabrias successfully led numerous naval attacks against the Spartans.
Balanced Tear-drop Handle: The handle of the WaterRower M1 LoRise is made of aluminum for strength and lightness, with a tear-drop shape that fits comfortably into the palm of the hand to minimize wrist torque - a common cause of tendonitis. Because of its strength and lightness, the drive strap of the WaterRower M1 LoRise is high-density polyester webbing, guided by nylon pulleys. The drive strap does not wear and is maintenance-free, requiring no messy lubrication.
One downside of the Waterrower for me are the footrests. Whilst they are perfectly adequate if you want to row in shoes, rowing barefoot, which is something I like to do, is impossible. The plastic is completely square at the bottom and has sharp edges that cut into your heels. I also found that my shoes get caught when trying to put them in and out of the holders, which is a bit irritating.

The WaterRower Oxbridge is hand crafted in solid Cherrywood. Like all woods, Cherrywood may vary in color from a red-brown to deep... red. The wood will darken in color with exposure to light. For this reason all WaterRower Cherrywood components are kept in light free rooms to protect from shadowing. A new WaterRower Oxbridge will therefore appear quite light in color. The wood will however darken over time reaching a rich reddish hue.Handcrafted rowing machine with inchwater flywheel inch that replicates actual rowing feelFlywheel sits in enclosed water tank to provide smooth, quiet, self-regulated resistanceSeries 4 performance monitor tracks workout intensity, stroke rate, heart rate, and moreStores upright; measures 84 x 21 x 22 inches (W x H x D) and weighs 117 poundsStores upright; measures 84 x 21 x 22 inches (W x H x D) and weighs 117 pounds read more
×